2009 — Crankshaft, Piston and Cylinder Liner Removal/Installation

HOME Table 3-23. Rod Bearing Journal Diameter 40. See Figure 3-142 . Move connecting rods so front con- necting rod points to rear, and rear rod points to front of engine. sm01144 Figure 3-140. Lubricate Bearings 38. See Figure 3-140 . Install rod bearings and lubricate bearing surface with Harley-Davidson Motorcycle Oil 20W50. In addition, a thin film of Lubriplate No. 105 Motor Assembly Grease (NAPA Part No. 765-2651) is recom- mended. Figure 3-142. Position Connecting Rods COLOR CODE H-D PART NO. Red 24412-01K Max Min Blue 24413-01K Max Min sm01143 bricate cle Oil Motor recom- sm01142 sm01145 2 1 3 Figure 3-141. Install Thrust Bearing 1. ALT (alternator side) 2.

G (green main bearing code) 39. See Figure 3-141. Install thrust bearing. Use a small 3. R (red rod bearing code) amount of grease on the back of the bearing to hold in Figure 3-143. Crankshaft Color Code position. 3-60 2009 VRSC Service: Engine . Install Thrust Bearing 1. ALT (alternator side) 2. G (green main bearing cod nstall thrust bearing. Use a small 3. R (red rod bearing code) the back of the bearing to hold in Figure 3-143. Cranksha e: Engine Figure 3-141 39. See Figure 3-141. I amount of grease on position. 3-60 2009 VRSC Servic e) ft Color Code