HOME 4.3 FUEL TANK REMOVAL sm01208 1 6 3 To prevent spray of fuel, purge system of high-pressure fuel before supply line is disconnected. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00275a) 7 1. Purge fuel supply line of high pressure gasoline. a. See Figure 4-1 . Disconnect fuel pump and sensor connector (6) [86B] from fuel pump/filter/sensor assembly. 4 5 b. Start engine and allow vehicle to run. 2 c. When engine stalls, operate starter for 3 seconds to remove any remaining fuel from fuel lines. 1. Top plate retaining ring 2. Top plate 3. Pressure fuel line 4. Vapor vent hose 5. Return fuel line 6. Fuel pump connector [86B] 7.
Fuel sensor connector [13B] 2. Remove right side cover and remove maxi-fuse. See 7.4 MAXI-FUSE . 3. Remove air box. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . Figure 4-1. Fuel Tank Top Plate To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 4. Disconnect negative battery cable. See 1.9 BATTERY MAINTENANCE . Gasoline can drain from the fuel line when disconnected from fuel tank. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. Wipe up spilled fuel immediately and dispose of rags in a suitable manner. (00260a) 5.
Determine how long before fuel pump/filter/fuel level sensor assembly can be re-installed. a. If fuel tank is to be left unattended for any length of time, remove fuel cap and drain fuel tank. Use a pump or siphon and an approved gasoline storage container of sufficient capacity. 6. At fuel rail, disconnect pressure fuel line (3), return fuel line (5) by compressing tabs with thumb and first finger. b. If fuel pump/filter/fuel level sensor assembly is to be repaired and reinstalled immediately, open fuel tank can be covered temporarily until fuel pump/filter/fuel level sensor assembly is installed. 7. Disconnect both fuel lines from fuel tank top plate.
Pull lines out of path of fuel pump/filter/fuel level sensor assembly. 8. Use opposite thumbs to push the vapor vent hose (4) off of outlet tube. 9. Disconnect fuel pump connector (6), and fuel level sensor connector (7). 10. Check that all components are out of path of fuel pump/filter/fuel level sensor assembly. NOTE • Motorcycles not equipped with the H-D Security System will have the siren connector terminated to a cap attached to the wiring harness of the fuel module connector. Pull the siren connector and press the wiring harness out of the way.
• Fuel pump/filter/fuel level sensor assembly is lightly spring loaded and will generate a small amount of upward force when fasteners are removed. 11. Remove six fasteners from top plate retaining ring (1) and remove retaining ring. 4-4 2009 VRSC Service: Fuel System