HOME 4.5 INTAKE AIR TEMPERATURE SENSOR (IAT) GENERAL Refer to the ELECTRICAL DIAGNOSTIC MANUAL for information on the function and testing of the intake air temper- ature sensor (IAT sensor). sm01185 REMOVAL To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. Remove right side cover and remove maxi-fuse. See 7.4 MAXI-FUSE . 2. Remove air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 3. See Figure 4-5 . Remove IAT sensor connector [89B]. Figure 4-5. Intake Air Temperature Sensor Location (typical) a. See Figure 4-6 . Depress wire form. b. Use rocking motion to detach connector from IAT. 5.
Install air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . Figure 4-6. IAT Connector Wire Form 6. Install main fuse. 7. Install right side cover. 2009 VRSC Service: Fuel System 4-7 under side of IAT sensor and pull IAT sensor from upper air box. NOTE A short length of tubing with an ID of 7.62 mm (0.312 in) can be pushed over the retaining fingers to ease the sensor removal. INSTALLATION 1. See Figure 4-7. Inspect IAT O-ring (1). Replace IAT sensor if O-ring is worn or damaged. 2. Apply clean engine oil to IAT sensor O-ring. 3. Install IAT sensor into upper air box. 4. Connect IAT sensor connector [89B]. sm01299 0.312 in