2009 — Installation

HOME 4.4 THROTTLE POSITION SENSOR (TP) GENERAL 4. See Figure 4-3 . Connect TP sensor connector (2). Refer to the ELECTRICAL DIAGNOSTIC MANUAL for information on the function and testing of the throttle position sensor (TP sensor). 5. Connect negative battery cable. 6. Install air box and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . REMOVAL 1. Remove air box and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . sm01184 3 Cover the throttle body bores with duct tape to prevent objects from falling down the injector bores. Do NOT use shop cloths or objects that could damage the throttle plates. (00212d) 1 2 2. See Figure 4-3 .

Cover air intakes (3) to prevent debris from entering cylinders. To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 1. Throttle position sensor (TP sensor) 2. TP sensor connector [88B] 3. Air intakes (covered) 3. Disconnect negative battery cable. Figure 4-3.Throttle Position Sensor 4. Unplug TP sensor connector [88B] (2) by pulling external latch outward and using rocking motion to remove. 5. Remove two screws to detach TP sensor (1) from throttle body. Discard screws. sm01298 INSTALLATION 1 2 • Throttle must be closed for proper installation of throttle position sensor.

NOTES • Throttle position sensor does not have to be adjusted. 1. See Figure 4-4 . With connector facing rear of vehicle, verify that shaft pocket of TP sensor fits over shaft on throttle body. 2. Align holes in TP sensor with holes in throttle body. NOTE TP sensor may have to be turned slightly for holes to align. 1. Shaft 2. Shaft pocket Figure 4-4.Throttle Position Sensor Installation 3. Install new screws and tighten to 2.0-2.8 Nm (18-25 in- lbs ). 4-6 2009 VRSC Service: Fuel System