2009 — Installation

HOME 4.7 THROTTLE BODY AND FUEL RAIL REMOVAL 1. Disconnect the idle speed control (IAC) connector. sm01193 2. DIsconnect the throttle position (TP) sensor. 3. See Figure 4-10 . Loosen throttle body clamps. 4. Detach throttle body from rubber seals by pulling up with a gentle rocking motion. If engine is in chassis, it is not necessary to disconnect throttle cables. Move throttle body and cables aside and secure away from engine. 5. See Figure 4-11 . Remove fuel rail/intake seal fasteners. Bottom nut is captured but should be held with a wrench for removal. Figure 4-11. Fuel Rail/intake Seal Fasteners (typical) 6. See Figure 4-12 .

Without disturbing the fuel rail, rotate rubber seal from under fuel rail. 7. Remove fastener holding the MAP sensor. Separate con- nector [80]. sm01194 8. See Figure 4-14 . Pull front injector from front intake runner. 9. With front injector free, swing fuel rail toward cam drive side and pull rear injector from rear intake runner. 10. See Figure 4-13 . Unplug connector [84], front injector and connector [85], rear injector. 11. Unplug engine coolant temperature sensor connector [90] and oil pressure sending unit connector [120]. 12. Unplug engine harness at connector [145]. 13. Disassemble and service fuel rail and fuel injectors. Figure 4-12. Rubber Seal sm01192 sm01195 Figure 4-10.

Loosen Throttle Body Clamps (typical) Figure 4-13. Fuel Rail with Injectors INSTALLATION 1. Assemble fuel rail. 2. Install fuel injectors. See 4.11 F 3. Connect engine harness at con 2009 VRSC Ser UEL INJECTORS. nector [145]. vice: Fuel System 4-11