HOME 4. Connect engine coolant temperature sensor connector [90] and oil pressure sending unit connector [120]. sm01197 5. See Figure 4-13 . Connect connector [84], front injector and connector [85], rear injector on fuel rail. 6. Supporting fuel rail oriented with fuel tubes toward the left rear, push rear injector into bore in intake runner. 7. Swing fuel rail over and push front injector into intake runner in front cylinder. 8. Rotate rubber boots under fuel rail and install rubber boots over intake runners. 9. Install fasteners through fuel rail into rubber boots.Tighten to 9.7 Nm (86 in-lbs ). Figure 4-15.Throttle Body Intake Clamps 10. See Figure 4-15 . Orient intake clamps as shown.
11. Press throttle body and cables into rubber boots. 12. See Figure 4-16 . Tighten intake hose clamps (7) to 1.25 Nm (11 in-lbs ). 13. See 1.22 SPARK PLUGS AND COIL . Install spark plugs and coils. Tighten to: a. Tighten spark plugs to 23 Nm (17 ft-lbs). b. Tighten coil fasteners to 9.7 Nm (86 in-lbs ). 14. Attach the idle speed control (IAC) connector. 15. Attach the throttle position (TP) sensor. 16. rail. Push until audible "click" is heard. NOTE sm01196 Figure 4-14. Front Injector 4-12 2009 VRSC Service: Fuel System rigid fuel lines fro eard. tat hose and insta g this procedure. m fuel ll front