HOME 4.8 IDLE AIR CONTROL (IAC) GENERAL sm01188 Stop the engine when refueling or servicing the fuel system. Do not smoke or allow open flame or sparks near gasoline. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00002a) 3 Refer to the ELECTRICAL DIAGNOSTIC MANUAL for information on the function and testing of the idle air control (IAC). 2 REMOVAL 1 1. IAC sensor connector [87B] 2. Idle air control (IAC) 3. Air intakes (covered) If a heat gun is required to remove screws that attach idle control flange to induction module, remove module before proceeding.
Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00270a) Figure 4-17. IAC Sensor (typical) INSTALLATION 1. Remove air box and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 1. Inspect IAC O-ring. Replace if damaged. 2. Apply clean engine oil to IAC O-ring. 3. Place idle air control and O-ring into throttle body. Be sure O-ring is properly seated in throttle body groove. 4. See Figure 4-18 . Apply LOCTITE Threadlocker 243 (blue) to screws (2). Loosely install front and rear IAC screws (2). 2. See Figure 4-17 . Cover air intakes (3) to prevent debris from entering cylinders. 5.
Tighten front and rear IAC screws to 2-4 Nm (25-35 in- lbs ). 6. Connect throttle cables to throttle body. 7. Install throttle body. See 4.7 THROTTLE BODY AND FUEL RAIL . To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 8. Connect negative battery cable. 3. Disconnect negative battery cable. 9. Install air box and air filter. See 1.8 ENGINE OIL AND FILTER . 4. Remove throttle body. See 4.7 THROTTLE BODY AND FUEL RAIL . 5. heat will cause damage to idle air control. 6. See Figure 4-18 screws. 7. 4-14 2009 VRSC Service:
Fuel System Cover the throttle body bores with duct tape to p objects from falling down the injector bores. Do N shop cloths or objects that could damage the t plates. (00212d) from throttle body. TE to idle air control. Apply only E patch on screws. Excessive air control. eat gun, apply heat to idle air ak LOCTITE patch. Remove 1 m throttle body (3). 1. IAC 2. Screws 3. Throttle body Figure 4-18. IAC R el System emoval