HOME 4.9 MANIFOLD ABSOLUTE PRESSURE SENSOR (MAP) REMOVAL 1. Remove air box and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . sm01190 1 Cover the throttle body bores with duct tape to prevent objects from falling down the injector bores. Do NOT use shop cloths or objects that could damage the throttle plates. (00212d) 2 2. Cover air intakes to prevent debris from entering cylinders. 3 4 To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 1. Bolt 2. Bracket 3. MAP sensor 4. Connector [80B] 3. Disconnect negative battery cable. 4. See Figure 4-19 .
Remove bolt (1) securing MAP sensor bracket (2) to front cylinder. Figure 4-19. MAP Sensor Location (typical) 5. Unplug MAP sensor connector [80B] (4) by pulling external latch outward and using rocking motion to remove. NOTE If the original sensor is installed, the grommet must be inspected. Grommets not in good condition could cause vacuum leaks. sm01191 1 INSTALLATION 1. Plug connector into MAP sensor. 2. See Figure 4-20 . Install bracket (2) over MAP sensor (3). 3. Install (push) MAP sensor and grommet to intake manifold. 2 3 4. Secure MAP sensor bracket with bolt. Tighten bolt to 6.0- 10.0 Nm (53.0-88 in-lbs ). 5. Connect negative battery cable. 1. Bolt 2. Bracket 3. MAP sensor 6.
Install air box and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . Figure 4-20. MAP Sensor 2009 VRSC Service: Fuel System 4-15