2009 — Installation

HOME sm03912 2. Thread oxygen sensor into header by hand until snug. 3. Route oxygen sensor cable as it was originally routed from the factory. Replace any cable ties removed when removing old sensor. 4. See Figure 4-22 . Locate and connect sensor connector to wiring harness. 5. Final tighten oxygen sensor to 40-60 Nm (29-44 ft-lbs). Rear Sensor To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) Figure 4-25. Rear Oxygen Sensor (typical - all except VRSCF shown) NOTES • Do not install sensors that have been dropped or impacted by other components. Damage to the sensing element may have occurred.

Replacement sensor assemblies have threads coated with anti-seize lubricant and new seal rings. INSTALLATION Front Sensor • Apply a thin coat of LOCTITE ANTI-SEIZE to threads of each oxygen sensor prior to installing in header. Do not use any other grease or sealant product on sensor threads. The electrical connector must also be clean and free of any dielectric grease. To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) NOTES 1. See Figure 4-21 .

If installing original oxygen sensor instead of a new sensor, apply a thin coat of anti-seize to thread of oxygen sensor, using caution not to get anti-seize on sensor ceramic at tip of sensor. • Do not install sensors that have been dropped or impacted by other components. Damage to the sensing element may have occurred. Replacement sensor assemblies have threads coated with anti-seize lubricant and new seal rings. 2. See Figure 4-25 . Thread oxygen sensor into header by hand until snug. • Apply a thin coat of LOCTITE ANTI-SEIZE to threads of each oxygen sensor prior to installing in header. Do not use any other grease or sealant product on sensor threads.

The electrical connector must also be clean and free of any dielectric grease. 3. Route oxygen sensor cable as it was originally routed from the factory. Replace any cable ties removed when removing old sensor. 4. See Figure 4-22 . Locate and connect sensor connector to wiring harness. 1. See Figure 4-21 . If installing original oxygen sensor instead of a new sensor, apply a thin coat of anti-seize to thread of oxygen sensor, using caution not to get anti-seize on sensor ceramic at tip of sensor. 5. Final tighten oxygen sensor to 40-60 Nm (29-44 ft-lbs). 6. Install oxygen sensor heat shield bracket.Tighten fastener to 8-12 Nm (71-106 in-lbs ). 2009 VRSC Service: Fuel System 4-17