HOME 4.11 FUEL INJECTORS GENERAL Fuel Pressure Regulator 1. See Figure 4-27 . Remove screws (5, 9). 2. Remove fuel pressure regulator clip (4) from fuel rail. When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) 3. Use rocking motion to detach fuel pressure regulator (1) from fuel rail. Fuel Tubes Refer to ELECTRICAL DIAGNOSTIC MANUAL for information on the function and testing of the fuel injectors. NOTE REMOVAL Do not remove fuel tubes, o-rings or spacers if not replacing. 1. Remove air box and air filter.
See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 1. See Figure 4-27 . Remove screws (5, 9). 2. Remove fuel pressure regulator clip (4) from fuel rail. 3. See Figure 4-28 . Pull feed (4) and return (5) fuel tubes from fuel rail. NOTE Figure 4-27. Fuel Rail Observe the position of the clamps for reassembly. ASSEMBLY 4. With throttle cables attached, wrap a shop towel around body for protection and secure away from engine. See 4.7 THROTTLE BODY AND FUEL RAIL . Fuel Injectors 1. Inspect fuel injector o-rings, replace if damaged DISASSEMBLY 2. Apply clean engine oil to fuel injector o-rings. Fuel Injectors 1. See Figure 4-27 . Remove screw (7). 3. Insert fuel injector into fuel rail. 2.
Pull fuel injector and clip from induction module. 4. Slide fuel injector clip into slot in fuel injector. 3. Remove clip from fuel injector. 5. Secure with screw and tighten to 2.0-2.8 Nm (18.0-25.0 in-lbs ). 4. Repeat procedure for other fuel injector. 6. Repeat for other fuel injector. 4-18 2009 VRSC Service: Fuel System To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 2. Disconnect negative battery cable. 3. Loosen clamps at each intake and lift throttle body straight up. sm01197 Figure 4-26.Throttle Body Intake Clamps sm01198 5 4 3 6 7 2 1 9 8 1. Fuel pressure regulator 2.
Fuel injector clip 3. Front fuel injector 4. Fuel pressure regulator clip 5. Screw 6. Rear fuel injector 7. Screw 8. Schrader valve 6.8-9.6 Nm (60.0-85.0 in-lbs) 9. Screw