HOME sm01178 When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) 3 5 13. Lift fuel pump/filter/fuel level sensor assembly out of the fuel tank. 1 14. Cover fuel tank opening or drain fuel tank as required. INSTALLATION 2 1. See Figure 4-30 . Apply a small dab of silicone gasket sealer to new fuel tank top plate O-ring. Install quad seal onto shoulder of tank opening. Let gasket sealer cure for five minutes. 6 4 Figure 4-31.Torque Sequence sm01177 3. See Figure 4-31 . Install top plate retaining ring and fasteners.
Tighten to 5-6 Nm (44-53 in-lbs ). 4. See Figure 4-29 . Mate fuel pump connector half (6), and fuel level sensor connector (7) while supporting the top plate connector half with opposite hand. NOTE To avoid bending connector pins, gently press connectors parallel or straight into pin module connectors. 5. See Figure 4-29 . Install return fuel line and larger pressure fuel line while supporting mating port. Press lines on until an audible click is heard that indicates engagement. Figure 4-30. Fuel Tank O-ring (typical) NOTE Be sure to connect fuel lines to correct ports and verify fuel lines are properly installed before starting vehicle.
Failure to connect fuel lines properly can result in a spray of gasoline when ignition switch is turned on. Gasoline is extremely flam- mable and explosive which could result in death or serious injury. NOTE Fuel pump/filter/fuel level sensor assembly is lightly spring loaded and requires a small amount of downward force when installing. Be sure not to pinch hoses when compressing assembly as this will obstruct fuel flow. 6. Press on fuel vapor vent hose while supporting mating port. 2. Insert fuel pump/filter/fuel level sensor assembly into fuel tank.
Allow top plate to fall into position and rubber spacer/bumper on bottom of fuel pump/filter/fuel level sensor assembly to rest on bottom of fuel tank. When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) 7. Connect negative battery cable. See 1.9 BATTERY MAINTENANCE . 8. Install air box. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 9. Close seat. 10. Replace the maxi-fuse and right side cover. 11. Check fuel system pressure. See 4.13 FUEL PRESSURE TEST . 2009 VRSC Service: Fuel System 4-21