2009 — Fuel Pump

HOME SUCTION SIDE FUEL FILTER FUEL PUMP General The fuel pump pumps fuel from the tank sump and provides filtered, pressurized fuel to the fuel rail. The fuel rail pressure is controlled by a pressure regulator.The injectors receive fuel directly from the fuel rail. The bypass fuel from the pressure regulator is returned to the tank sump via the external fuel return line. Gasoline can drain from components when disconnected from fuel pump/filters/fuel level sender assembly. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. Wipe up spilled fuel immediately and dispose of rags in a suitable manner. (00273a) See Figure 4-33 .

The suction side filter filters the fuel as it enters the strained intake of the fuel pump. The suction side filter is replaced at the service interval of 161,000 kilometers (100,000 miles). When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) PRESSURE SIDE FUEL FILTER See Figure 4-32 . The pressure side filter filters the fuel before it enters the pressure fuel line. The pressure side filter is ser- viced at a service interval of 40,233 kilometers (25,000 miles) or any time the fuel pump is serviced.

NOTE Before removing the fuel pump, perform appropriate diagnostics listed in the VRSC ELECTRICAL DIAGNOSTIC MANUAL. Removal Removal 1. See Figure 4-32 . To remove, slide clip (2) outward. 1. See Figure 4-33 . Remove fuel pump electrical connector (9) from fuel pump. 2. Disconnect base (3) from fuel filter canister (1). 3. Pull fuel o-ring and filter from fuel filter canister. 2. Depress fuel pump supply hose mounting tabs (8) and disconnect fuel pump supply hose (1). Depress suction side fuel filter mounting tabs (7) and dis- NOTE . Route fuel pump supply hose (1) through new fuel pump (5) Figure 4-32. Pressure Side Filter 4.

Install new suction side filter (4) by pressing into place until an audible click is heard. Installation 1. Insert a new canister (1). . 2. Install fuel filter base (3). 3. is heard (2). sm01179 1 2 3 1. Fuel filter canister 2. Fuel filter canister clip 3. Fuel filter base connect suction sid 4. Remove fuel pump damper) from housi 5. Push fuel pump up 6. Inspect all fuel pum Carefully inspect hoses f Replace hose if any dam can cause a reduction in Installation 1. See Figure 4-33. Ro cavity in fuel pump h with vibration isolato 2. Insert fuel pump su until an audible click 3. Align fuel pump so between two fuel pu install fuel pump ret until an audible click 5.

Press fuel pump electrical co an audible click is heard. side filter and o-ring into fuel filter 6. Install fuel pump/filter/fuel lev 7. After installation of fuel pu ). assembly, verify fuel pump o pressure test. See 4.13 FUEL clip into place until an audible click Fuel System nnector (9) into pla el sensor into fuel ta mp/filter/fuel level peration with a fuel PRESSURE TEST