HOME 4.13 FUEL PRESSURE TEST GENERAL TOOL NAME PART NUMBER sm01200 DIGITAL TECHNICIAN II HD-48650 When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) The fuel pump is located in the fuel tank. It delivers fuel to the fuel metering assembly. The fuel metering assembly contains the fuel injectors, and the pressure regulator where the system pressure is controlled. Excess fuel pressure is returned to the fuel tank by a return line. The ECM controls the system relay that supplies 12 VDC to the fuel pump. Figure 4-34.
Fuel Pump Connector [86] (typical) When the engine is stopped, the fuel pump can be turned on by applying battery voltage to pin 1 and ground to pin 3 of the fuel pump connector [86A] or by using DIGITAL TECHNICIAN II (Part No. HD-48650). Improper fuel system pressure may contribute to one of the following conditions: sm01201 3 • Cranks, but won't run. • Cuts out (may feel like ignition problem). • Hesitation, loss of power or poor fuel economy. NOTE See the ELECTRICAL DIAGNOSTIC MANUAL for further information on the function and testing of the fuel system. TESTING 1 TOOL NAME PART NUMBER 2 FUEL PRESSURE GAUGE HD-41182 1. 1/8 in. pipe thread 90° elbow 2. Fuel valve 3.
Schrader valve adapter The fuel pressure gauge 0-690 kPa (0-100 PSI) allows for fuel injector and fuel system pressure diagnosis. 1. See Figure 4-34 . Disconnect fuel pump connector from top of fuel tank. Figure 4-35. Fuel Pressure Gauge Valves 2. Start the engine and allow the vehicle to run. 3. When engine stalls, operate the starter for 3 seconds to remove any remaining fuel from the fuel lines.Turn ignition key off. 4. See Figure 4-35 . Insert a 1/8 in. pipe thread 90 degrees (right angle) elbow (1) between the fuel valve (2) and the Schrader valve adapter (3). 5. 6. See Figure 4-36. Rem valve in fuel metering a Verify that the fuel va ove protective cap from Schrader ssembly.
lve and air bleed petcock on the AUGE (Part No. HD-41182) are 2009 VRSC Ser FUEL PRESSURE G closed.