HOME sm01202 original reading then you have a defective line, regulator, injector or pump check valve. 11. Turn the engine off. Open the air bleed petcock to relieve the fuel system pressure and purge the pressure gauge of gasoline. Gasoline can drain from quick-connect fitting when removing fuel line. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. Wipe up spilled fuel immediately and dispose of rags in a suitable manner. (00267a) 12. Remove fuel pressure gauge from the Schrader valve in fuel metering assembly. Install protective cap over Schrader valve. Figure 4-36. Schrader Valve Location (typical) 7. fuel pump connector. 8.
the pressure gauge. 9. tube. Close the petcock. 10. remain steady at 380-425 kPa (55-62 psi). NOTE monitor the fuel pressure gauge. If it drops notably from your Figure 4-37. Fuel Pressure Gauge Installed 4-26 2009 VRSC Service: Fuel System Schrader valve. Connect ze the fuel system. Open of fuel down the hose of e in a suitable container ed petcock to purge the is step several times until flows from the air bleed e engine speed. Note the . Fuel pressure should 55-62 psi). erved and recorded, and ait several minutes and sm01203