2009 — Removal

HOME 4.14 EXHAUST SYSTEM: VRSCAW REMOVAL 5. Remove both heat shields (21, 20) from front and rear header pipes. It is not necessary to remove the heat shield (14) from the auxiliary volume (24). 6. Remove the auxiliary volume fastener (1) and the lower muffler fastener (1) from the lower part of the exhaust support bracket. Save the L-bracket (27) found under the exhaust support. To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. Remove right side cover and remove main fuse. See 7.4 MAXI-FUSE . 7. Disconnect oxygen sensor (8) connectors from wiring harness. 2. See Figure 4-38 . Loosen upper muffler clamp (18).

8. Remove the left side drive sprocket cover for easier access to rear cylinder lower exhaust flange bolt. 3. Remove the two fasteners (1) holding the upper muffler (25) to the bottom muffler (26). 9. Remove flanged hex-nuts (4) holding exhaust flange to front and rear cylinders. 4. Slide upper muffler rearward to disconnect from the auxil- iary volume (24). 10. Remove hex-nut (4) and pin (11) on exhaust support bracket. 11. Remove front exhaust pipes from cylinder heads. 2009 VRSC Service: Fuel System 4-27