HOME INSTALLATION NOTE TORCA muffler clamps have eliminated the need for silicone or graphite tape during assembly. To ensure sealing integrity of muffler clamps, and prevent the possibility of leakage, Harley-Davidson recommends that the muffler clamp assem- blies be discarded and replaced each time they are removed. Do not torque fasteners until required to do so by the following installation instructions. Hand tightening each fastener will pull the exhaust system into a position that will allow the crush of the exhaust gaskets during the torquing sequence to draw the exhaust system up to the engine. NOTE 9. Place clamp (18) on upper muffler (25).
Slide muffler over upper opening of auxiliary volume (24). Position clamp with compression fastener to inboard with tightening nut upward. 1. Install new exhaust seals (19). 2. See Figure 4-38 . Gently lift the lower muffler, auxiliary volume, and header pipe assembly into position. 10. Thread upper muffler fasteners (1) into the lower muffler (26). Do not tighten. NOTE An assistant may be required to hold the header pipes when aligning the exhaust header flanges with the studs in the cyl- inder heads. 11. Torque the fasteners to the indicated torque in the fol- lowing order: a. Upper muffler clamp - 65 Nm (48 ft-lbs). 3.
Slip both front and rear header flanges (15) over the studs in the cylinder heads. Thread hex-nuts (4) on header flange studs. Do not tighten. b. Upper muffler fasteners - 23 Nm (17 ft-lbs). c. Lower muffler fasteners - 23 Nm (17 ft-lbs). 4. Install support pin (11) in isolator mount (17) on the exhaust support.Thread on the hex-nut (4). Do not tighten. d. Auxiliary volume fasteners - 23 Nm (17 ft-lbs). 5. Hold a 1/2 in. spacer between the frame rail and the header pipe exhaust clamp. e. Exhaust flange hex-nuts - 8-12 Nm (71-106 in-lbs ). 12. Check the tightness of the exhaust clamp by tightening the clamp nut to 32-37 Nm (24-27 ft-lbs). 6.
Thread in the lower muffler fastener (1) through the exhaust support. 13. Reinstall front and rear heat shields. Tighten the heat 7. Thread in the auxiliary volume fastener (1) through the L- shield fasteners to 10 Nm (88 in-lbs ). 8. 2009 VRSC Service: Fuel System 4-29 ust support. Do not tight 23 Nm (17 ft-lbs). 14. If removed, reinstall en. Nm (53-88 in-lbs). 15. Mate oxygen senso 16. Install the maxi-fuse