2009 — Installation

HOME be replaced with new fasteners and tightened properly. Failure to do so can result in the heat shield coming loose and interfering with rear brake pedal operation which can cause loss of vehicle control and death or serious injury. sm04990 • An assistant may be required to hold the exhaust pipes while guiding exhaust system onto motorcycle. sm04989 Figure 4-40. Right Side Passenger Footrest/Exhaust Bracket Fastener Figure 4-41. Exhaust Lower Support Fastener Location 1. Verify brake hose between master cylinder and reservoir is completely seated in retainer clips along lower frame 6. Install passenger footrest and bracket assembly. See 2.8 RIDER FOOTRESTS AND FOOT CONTROLS . 2.

Install new figure 8 clamp. 3. 4. into the exhaust pipes. Make sure heat shield on muffler assembly fits over heat shield on exhaust pipes. NOTE Check clearance between bottom of exhaust and frame of motorcycle. There should be a measured clearance no less than 5.7 mm (7/32 in). Clearance less than this can result in damage to the rear brake reservoir to master cylinder hose which can cause loss of vehicle control and death or serious injury. 5. See Figure 4-39 . Install all fasteners loosely. Do not tighten at this time. 9. Check clearance between frame and exhaust system. Clearance should be no less than 5.7 mm (7/32 in).

If adjustment is necessary, loosen exhaust pipes, all mounting fasteners and reposition exhaust system and check clearance again. 4-32 2009 VRSC Service: Fuel System missing clips and of frame tube as po ssembly into positi rom the muffler as verify ssible. 7. Tighten lower muffler mounting fastene 20 ft-lbs) and lower volume mounting Nm (14-20 ft-lbs). on. 8. Tighten figure 8 clamp to 30-34 Nm (2 sembly