HOME 4.16 EXHAUST SYSTEM: VRSCF REMOVAL 6. Remove stud plates. 7. Remove mufflers, one at a time. NOTE • If muffler end caps must be replaced, remove screws (22), washers (20) and lockwashers (21) and remove end caps and replace as necessary. To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. Remove right side cover and remove maxi-fuse. See 7.4 MAXI-FUSE . • There are different end caps for non-HDI and HDI models; consult the correct parts book for part replacement. 2. See Figure 4-42 . Remove upper right heat shield (4), lower right heat shield (5) and left heat shield (6). 8.
Loosen TORCA clamp (10) securing rear exhaust cros- sover pipe (3) to front exhaust pipe (1). 3. Disconnect front and rear oxygen sensors (14). 9. Remove the flanged hex-nuts holding exhaust flanges (2) to front and rear cylinder heads. NOTES • Do not remove the fastener securing the rear of each muffler to the pin in the end of the exhaust support.When you remove the muffler, the exhaust support pin will remain with each muffler and the rubber isolator will remain with the exhaust support. 10. Slide exhaust flange down header pipe to improve clear- ance around exhaust port. 11. Remove rear exhaust pipe (3). 12. Remove TORCA clamp from crossover pipe. Discard TORCA clamp.
• TORCA clamps are spot welded to the header pipe and will require a twisting action to remove. 13. Remove front exhaust pipe (1). 4. Loosen TORCA clamps (11) securing mufflers (7, 8) to exhaust pipes (1, 3). 14. Remove and discard exhaust seal (25) from exhaust pipe, remove retaining rings (23) and exhaust seals (24) from front and rear exhaust ports. 5. Remove fasteners on stud plates (18) securing mufflers to left and right exhaust supports (9). 2009 VRSC Service: Fuel System 4-33