2009 — Pressure Cap

HOME 5.2 COOLANT FLOW GENERAL The pressure cap and radiator filler neck pressurize the coolant system.When the coolant pressure exceeds the pressure cap lower limit of 96 kPa (14 psi), the lower valve opens and the excess pressure and expanded coolant flow to the overflow bottle through the overflow tube. The overflow bottle is vented to the atmosphere through a long tube which loops over the top of the radiator/oil cooler assembly and down below the coolant level. When the pressure drops, the pressure cap vacuum valve opens to draw coolant back into the coolant inlet pipe from the overflow bottle. Coolant mixture contains toxic chemicals, which may be fatal if swallowed.

If swallowed, do not induce vomiting; call a physician immediately. Use in a well ventilated area. Irritation to skin or eyes can occur from vapors or direct contact. In case of skin or eye contact, flush thoroughly with water and go to hospital, if necessary. Dispose of used coolant according to federal, state and local regula- tions. (00092a) TROUBLESHOOTING The VRSC engine is cooled by a an ethylene-glycol coolant and the lubricating engine oil. The Troubleshooting section of this manual is a guide to diagnose problems. Read the appropriate sections of this manual before performing any work. Improper repair and/or maintenance could result in death or serious injury.

(00528b) The ethylene-glycol coolant is pressurized and circulated through the engine and a cooling radiator by an impeller type water pump utilizing a thermostat controlled bypass. The coolant pressure determines the coolant boiling point.The boiling point rises as the pressure increases and drops as the pressure decreases. At the rated system pressure of 103 kPa (15 psi), the boiling point rises to over 121° C (250° F). Low Engine Temperature 1. Open thermostat. The engine oil also cools the engine. Specifically, an oil jet under each piston sprays a mist of oil to lower the operating temperature of that piston. See 3.4 OIL FLOW . 2. Defective engine coolant sensor. 3.

Defective cooling fan. As coolant exits the pump, it flows through the crankcase and around the cylinder liners removing the heat build-up caused by the motion of the piston rings. From the cylinder liners, the coolant flows up through the cylinder head and around the exhaust valves and combustion chamber. After the coolant passes around the combustion chamber, it then flows back through the closed thermostat into the pump to repeat the cycle. This flow continues until the coolant reaches 85° C (185° F) and the thermostat opens. 4. Faulty water pump. 5. Low coolant level. 6. Air in hoses, pipe or passages. 7. Defective pressure cap. 8. Defective engine coolant sensor.

Once the coolant exceeds 100° C (212° F), the thermostat remains open and blocks the by-pass between the entrance and exit ports of the case. Coolant Leaks 1. Damaged pressure cap gasket. 2. Faulty water pump. An engine coolant temperature (ECT) sensor is mounted to the thermostat. If the temperature should exceed 117° C (243° F), the engine coolant temperature indicator on the instrument cluster will illuminate. 3. Deteriorated o-rings on water pump. 4. Damaged engine gasket. 5. Leaking hose or hose connection.

After the coolant leaves the cylinder heads, it flows through the radiator coolant inlet pipe (5) to the radiator.The ethylene- glycol is cooled as it flows through the radiator from left to right. PRESSURE CAP The pressure cap and radiator filler neck pressurize the coolant system. The pressure cap's upper spring diaphragm gasket seals to the upper sealing seat in the filler neck. The lower pressure limiting valve in the pressure cap seals to the lower seat. The filler neck has an overflow tube between and upper and lower sealing seat.

To increase the amount of air flowing through the radiator, two cooling fans will turn on when the coolant temperature exceeds 103° C (217° F) and will turn off when the temperature drops The coolant exits the top right of the radiator and flows through the radiator outlet coolant pipe to the coolant pump inlet. Rising pressure compresses the spring and the lower valve opens. Excess pressure and expanded coolant flow to the 2009 VRSC Service: Cooling System 5-3 FLOW DESCRIPTION High Engine Tem coolant 1. Stuck thermostat. hamber 2. Blocked hoses, pipe age to 3. Defective cooling fa .

To warm the engine up quickly, the ethylene-glycol is re-circulated through the cylinders and combustion c in the cylinder heads. The thermostat blocks the pass the radiator to recirculate the coolant. 103° C 98° C