HOME overflow bottle through the overflow tube. When the pressure drops, the vacuum valve opens to draw coolant back into the radiator through the overflow tube from the overflow bottle. PRESSURE CAP TEST TOOL NAME PART NUMBER COOLANT SYSTEM PRESSURE TESTER HD-45335 sm00610 2 The pressure cap should be tested for the correct operating range every time the antifreeze is changed or any cooling system maintenance performed. Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) 3 1 1.
See Figure 5-2 Using a cloth over pressure cap, turn cap 1/4 turn counterclockwise (CCW) to safety stop (2). Let pressure escape. Press down and turn cap to pass over safety stops and remove. 4 1. Upper sealing gasket 2. Spring diaphragm 3. Lower sealing gasket 4. Vacuum valve 2. Inspect cap for gasket deterioration and broken springs. 3. Turn butterfly valve parallel to boss on COOLANT SYSTEM PRESSURE TESTER (Part No. HD-45335) tester head and turn pressure cap adapter onto tester head. Turn butterfly valve perpendicular to seal tester head. Figure 5-1. Pressure Cap NOTE To test new caps, wet the upper sealing gasket before turning onto adapter. 1 sm00611 4. Turn pressure cap onto adapter.
Rotate to safety stops. 5. See Figure 5-2 . Pump handle to pressurize pressure lim- iting valve in cap. Stop pumping when pressure valve in cap opens. 5 6. Replace pressure cap if: a. Leaks below low limit, 96 kPa (14 psi). 4 2 b. Opens above high limit, 124 kPa (18 psi). c. Pressure falls rapidly when pressurized within range. 7. Open butterfly valve and remove adaptor and cap. 3 1. Upper sealing seat 2. Safety stop at Filler Neck (typical) : Cooling System Figure 5-2. 5-4 2009 VRSC Service