HOME sm00612 NOTE When performing the coolant system pressure test, never exceed the upper limit rating of the pressure cap. Excessive pressure can rupture cooling pipes, hoses, and radiator. 6. Pump tester until pressure reaches 103 kPa (15 psi). 7. Refer to Table 5-5 . Match movement of needle to system pressure. 8. Release pressure in system by turning butterfly pressure valve perpendicular to head.Wait until pressure is released before removing double ended cap from filler neck. Table 5-5. System Pressure Test NEEDLE MOVE- MENT Holds steady for 2 minutes Drops slowly Drops quickly Figure 5-4. System Pressure Test (typical) 2.
Using a cloth over pressure cap, turn cap 1/4 turn counter- clockwise (CCW) to safety stop. Let pressure escape. Press down and turn cap to pass over safety stops and remove. LEAK DETECTION DYE TEST 3. See Figure 5-2 . Clean and inspect filler neck, upper (1) and lower (5) sealing seats, overflow tube (4), and overflow bottle. TOOL NAME PART NUMBER COOLANT FLUORESCENT LEAK DETECTION DYE HD-29545-6 NOTE Bent filler neck cams and safety stops can cause cap to leak or affect pressure limiting valve. Replace the coolant pipe as required.
BLACK LIGHT LEAK DETECTOR HD-35457 NOTE If the coolant overflow bottle is empty when the engine is cold, it is possible that air has been drawn into the coolant system. The system must be purged of any trapped air and refilled with coolant. 4. See Figure 5-4 . Turn butterfly valve parallel to boss on COOLANT SYSTEM PRESSURE TESTER (Part No. HD- 45335) head and turn adapter onto head. Turn butterfly valve perpendicular to seal head to adapter. 1. Before troubleshooting cooling system be sure engine coolant level is at COLD FULL mark on overflow bottle when the motorcycle is on the jiffy stand. NOTE Wet the upper sealing surfaces before turning adapter onto tester head. 5.
Turn double ended pressure cap onto the end of the adapter and onto filler neck. Rotate to the safety stops. 2009 VRSC Service: Cooling System 5-5 LEAK ACTION 2 None None Small Dye test Major Visual Figure 5-3. Pressure Cap Test SYSTEM PRESSURE TEST PART NUMBER TOOL NAME HD-45335 COOLANT SYSTEM PRESSURE TESTER The cooling system can be pressure tested to identify a leak and to verify a blown engine gasket. 1. Before troubleshooting cooling system, be sure engine coolant level is at COLD FULL mark on overflow bottle sm00613 PART NUMBER HD-45335 COOLANT SY TESTER STEM PRESSUR