2009 — Tests for Blown Gasket

HOME TESTS FOR BLOWN GASKET Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) TOOL NAME PART NUMBER COOLANT SYSTEM PRESSURE TESTER HD-45335 If a pressure test indicates a leak but there is no visible leak, even after a leak detection dye test, perform the following tests to verify a damaged engine gasket. 2. Using a cloth over pressure cap, turn cap 1/4 turn counter- clockwise (CCW) to safety stop. Let pressure escape. Press down and turn cap to pass over safety stops of filler neck and remove. 1.

Start and run cold engine. White smoke from exhaust system indicates a blown gasket. 3. If filler neck is full of coolant, remove an amount of coolant equal to the amount of dye. 2. Run engine. Shut off engine. a. Remove oil level dipstick. Light colored foam on dip- stick indicates a blown gasket. 4. See Figure 5-5 . Pour COOLANT FLUORESCENT LEAK DETECTION DYE (Part No. HD-29545-6) into filler neck. b. Open oil drain plug and drain a small amount of oil. Water or coolant will drain out first if gasket is blown. sm00614 NOTES • Do not allow pressure to build up past the maximum for system.

If pressure rises past, turn off engine and turn butterfly pressure valve perpendicular to tester head to release pressure. • Do not continue to run engine unattended with COOLANT SYSTEM PRESSURE TESTER installed. There is no safety valve with the pressure cap removed and the COOLANT SYSTEM PRESSURE TESTER installed. 3. With COOLANT SYSTEM PRESSURE TESTER (Part No. HD-45335) installed, start cold engine and idle engine to normal operating temperature. a. If gauge indicates fast pressure build up, a gasket is blown. Figure 5-5. Pouring Dye into Filler Neck 5. Reinstall pressure cap and run engine for 10 minutes. b. If pressure does not build up immediately, pump tester to system pressure.

If gauge needle vibrates, there is a compression or combustion leak. Disconnect one spark plug at a time. The needle will stop vibrating when spark is removed from leaking cylinder. 6. Use BLACK LIGHT LEAK DETECTOR (Part No. HD- 35457) to illuminate entire cooling system. A yellow fluor- escence at any spot indicates a leak. 7. Remove oil dipstick and inspect engine oil for yellow dye. NOTE NOTE After replacing an engine head gasket, draining and replacing contaminated oil will be necessary as part of engine service. Dye in the oil may indicate a damaged engine head gasket. Draining and replacing coolant contaminated oil will be necessary as part of engine service. 5-6 2009 VRSC Service:

Cooling System