HOME sm00617 Coolant mixture contains toxic chemicals, which may be fatal if swallowed. If swallowed, do not induce vomiting; call a physician immediately. Use in a well ventilated area. Irritation to skin or eyes can occur from vapors or direct contact. In case of skin or eye contact, flush thoroughly with water and go to hospital, if necessary. Dispose of used coolant according to federal, state and local regula- tions. (00092a) 12. See Figure 5-8 . Loosen air bleed plug. 13. Through the filler neck, fill with GENUINE HARLEY-DAV- IDSON EXTENDED LIFE ANTIFREEZE & COOLANT up to lower sealing surface in filler neck. 14. Reinstall pressure cap and tighten air bleed plug to 9-11 Figure 5-8.
Air Bleed Plug @ 9-11 Nm (80-97 in-lbs) Nm (80-97 in-lbs ). 15. Reinstall air filter, air filter top, and air box cover. 6. See Figure 5-6 . Remove left side radiator trim cover. Place a container under engine coolant radiator. 16. Reinstall main fuse and side cover. 17. After running engine, check coolant level in overflow bottle with coolant cold with motorcycle on jiffy stand. If level is below COLD FULL line, add antifreeze to overflow bottle until fluid level reaches COLD FULL line. 7. See Figure 5-9 . Loosen but do not remove radiator drain plug. Orient radiator drain plug so that slot in threads is open to container and allow coolant to drain from the radiator. 18.
Continue to run engine, check level, and add antifreeze until fluid level remains at COLD FULL line with motorcycle on jiffy stand. 8. Hand tighten radiator drain plug. NOTE Locate dot on coolant drain plug.This indicates location of the drain slot is in drain plug. Correct torque on the radiator drain sm00618 plug is 2.3-2.8 Nm (21-24 in-lbs). 9. See Figure 5-7. Place a container under engine and remove front cylinder coolant drain plug. Allow remaining coolant to drain from engine. NOTE With the motorcycle in normal orientation, there is no need to remove the rear cylinder coolant drain plug. 10. Install and tighten front cylinder coolant drain plug to 9.7 Nm (86 in-lbs). 11.
Reinstall radiator trim cover. De-ionized water must be used with the antifreeze in the cooling system. Hard water can cause scale accumulation in water passages which reduces cooling system effi- ciency, leading to overheating and engine damage. (00195a) Figure 5-9. Slot in Radiator Drain Plug 5-8 2009 VRSC Service: Cooling System Figure 5-9. Slot in Rad : Cooling System iator Drain Plug