HOME 5.4 THERMOSTAT GENERAL 14. Press on end of tool to compress thermostat spring while turning tool 90 degrees counterclockwise (CCW). Remove thermostat. The thermostat is a valve that remains closed until the engine reaches operating temperature.When the coolant temperature exceeds 85° C (185° F), the thermostat opens allowing engine coolant to flow out of the engine to the radiator.The thermostat is fully open at 100° C (212° F). sm00619 1 2 REMOVAL 3 TOOL NAME PART NUMBER 6 THERMOSTAT REMOVAL TOOL HD-45307 Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns.
Allow engine to cool before servicing the cooling system. (00091a) 4 4 3 1. Allow cooling system and engine to cool. 3 2. Remove right side cover and main fuse. 3. Open seat and remove pressure cap. 5 4. Remove left side radiator trim cover. 1. Engine coolant temperature sensor 2. Thermostat housing 3. O-ring 4. Thermostat tube 5. Gasket 6. Tabs 5. Loosen radiator drain plug and orient slot in drain plug to drain engine coolant into suitable container. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 6. Hand tighten radiator drain plug. NOTE Correct torque on the radiator drain plug is 2.3-2.8 Nm (21-24 in-lbs ). Figure 5-10.Thermostat and Housing 7.
Remove air filter cover, air filter top, air filter, breather hose, velocity stacks, and air filter bottom. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . INSTALLATION TOOL NAME PART NUMBER 8. Remove pipe clamp and P-clamp from coolant pipes. THERMOSTAT REMOVAL TOOL HD-45307 9. Loosen lower clamp on hose to engine coolant pipe. Pull coolant outlet pipe and hose up. 1. See Figure 5-11 . To install new thermostat into housing, engage slots of THERMOSTAT REMOVAL TOOL (Part No. HD-45307) into tabs of thermostat while compressing thermostat spring. Turn tool 90° clockwise (CW) to lock thermostat into housing. 10. Loosen and remove fasteners and lock washers holding housing to engine case.
Pull thermostat housing off engine. 11. See Figure 5-10 . Disconnect coolant temperature sensor (1) from wiring harness. NOTE New components can be lubricated with engine coolant to ease assembly. NOTE See Figure 5-10 .The sensor (1) for the engine coolant temper- ature is threaded into the engine side of the thermostat housing. When illuminated red, the engine coolant temperature indicator lamp on the instrument cluster indicates that the coolant tem- 2. See Figure 5-10 .With new o-rings (3) on thermostat tubes (4), push tubes into engine case. 3. Connect engine coolant temperature sensor (1) to wiring 12. 13. 85° C (185° F ture has exceeded 117° Pull thermostat tubes (4 See Figure 5-11.
To re engage tabs on thermo 117° C (243° F). 4. Be sure lower clamp is in place ) and O-rings (3) out of engine. pipe. move thermostat from housing, 5. Orient new thermostat housing stat with slots of THERMOSTAT face on engine case. No. HD-45307). 6. Push housing pipe into pipe h tubes (4). Fit housing (2) to eng 2009 VRSC Servic REMOVAL TOOL (Part No. HD-45307)