HOME sm00630 NOTE A lubricant, such as tire soap or detergent and water, can be used to lubricate the hose to aid in pushing hose over neck beads. 5. Thread on mounting bolts (1) holding bearing housing assembly (5), water pump insert (4) and water pump cover (2) over water pump cavity. 6. Tighten water pump mounting bolts to 9.7 Nm (86 ). 7. Push pump to engine coolant pipe hose on cover outlet pipe (3). 8. Install lower bright hose clamp and tighten to 3-4 Nm (27-35 in-lbs ). 9. Install and tighten hose cover to 3-4 Nm (27-35 in-lbs ). 10. Install pipe clamp and p-clamp. See 5.6 COOLANT PIPES AND HOSES . 11. Loosen air bleed plug.
Fill with GENUINE HARLEY-DAV- IDSON LIFE ANTIFREEZE & COOLANT through filler neck. Figure 5-14. Water Pump Bearing Housing Assembly (clutch cover removed for clarity) 12. Tighten air bleed plug to 9-11 Nm (80-97 in-lbs ) and install pressure cap. INSTALLATION 13. Install maxi-fuse and right side cover. 1. Clean engine cavity. 14. Rinse motorcycle with water to remove any spilled coolant. 2. See Figure 5-15 . Lube and install bearing housing assembly (5). 15. After running engine, check coolant level in overflow bottle 3. Install new engine block. 4. pump into engine cavity. on jiffy stand. 5-12 2009 VRSC Service:
Cooling System 9.7 Nm (86 in-lbs stall new o-ring umbers facing aw ve shaft and pus (6) on with coolant cold an below COLD FULL ay from and add antifreeze line. h water 16. Continue to run eng until fluid level remai