HOME 5.5 WATER PUMP REMOVAL sm00628 Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) 1. Allow cooling system to cool. 2. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 3. Open seat and remove pressure cap. 4. Remove left side radiator trim cover. Figure 5-12. Removing Cover 5. Loosen and orient slot in radiator plug to drain engine coolant into suitable container. 6. Place a suitable container under engine and remove front engine coolant drain plug to drain coolant from engine.
sm00629 NOTE With the motorcycle in normal orientation, there is no need to remove the rear engine coolant drain plug. 7. Hand tighten radiator drain plug. NOTE Correct torque on the radiator drain plug is 2.3-2.8 Nm (21-24 in-lbs ). 8. Install and tighten front engine coolant drain plug to 9.7 Nm (86 in-lbs ). 9. Reinstall left side radiator trim cover. 10. Remove air box cover. Remove air filter top and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . Figure 5-13. Removing Water Pump (clutch cover removed for clarity) 11. Remove pipe clamp and p-clamp from coolant pipes. See 5.6 COOLANT PIPES AND HOSES . 12.
Remove hose cover clamp from upper end of hose to coolant pipe and loosen lower hose clamp. Pull coolant pipe up. 13. See Figure 5-12 . Unbolt water pump bolts and remove water pump cover. 14. Remove the insert. 15. See Figure 5-13 . Using a soft mallet, tap on side of water pump to loosen. 16. See Figure 5-14 . Remove bearing housing assembly with the o-rings and gasket. 2009 VRSC Service: Cooling System 5-11