2009 — Installation

HOME 29. Repeat to remove the oil line from the crankcase (oil in) oil line fitting. See 5.7 OIL LINE FITTINGS . 5. Thread on but do not tighten nuts holding radiator/oil cooler assembly to engine mount studs. 30. Remove nuts holding radiator assembly to engine mount studs and remove radiator/oil cooler assembly. 6. Push oil line into oil in fitting on crankcase. Snap plastic ring around spring clip groove on fitting. See 5.7 OIL LINE FITTINGS . 31. Retain bushings, grommets and washers. INSTALLATION 7. See Figure 5-24 . Slip grommets (23) into cross member on frame. Install radiator into cross member on frame. 8. Tighten cooling system fasteners to following: a.

Cross member fasteners to 20-26 Nm (15-19 ft-lbs). Clean the inlet surface of the radiator regularly. Leaves and other debris can collect on the radiator surface and degrade radiator performance which could lead to engine overheating and engine damage. (00197c) b. Top mounting nuts (8) to 19-27 Nm (14-20 ft-lbs). c. Pipe clamp to 6.5 Nm (57 in-lbs ). 1. Cover front fender with a shop towel or protective cover. d. P-clamp to 6-10 Nm (53-88 in-lbs ). e. Hose clamps to 3-4 Nm (27-35 in-lbs ). 2. Hold radiator/oil cooler assembly up to frame. 9. Route overflow hose (15) to overflow bottle. 3. Line up and fit inlet and outlet pipes to radiator hoses. 10. Install radiator cover. 4.

Push oil line into oil out fitting on oil filter. Snap plastic ring around spring clip groove on fitting. See 5.7 OIL LINE FITTINGS . 2009 VRSC Service: Cooling System 5-21