2009 — Removal

HOME sm00620 sm00640 2 3 1 4 2 1. Chrome inlet bezel 2. Fastener and washer 3. Coolant drain plug 4. Radiator cover Figure 5-22. Dot on Coolant Drain Plug Figure 5-23. Left Side Radiator (typical) (forward controls model shown) drain slot in drain plug. NOTE NOTE bottle also remains clipped to the assembly. 12. See Figure 5-23 plug (3). Turn drain plug until slot in threads drains into container. 21. Use a LONG THIN SCREWDRIVER (Part No. SNAP-ON SDD1410) to loosen worm drive clamps on both engine coolant hoses at radiator. 13. Open seat and remove pressure cap to accelerate coolant drain from radiator. 14. Hand tighten coolant drain plug. See 5.3 ENGINE COOLANT . 22. See Figure 5-24 .

Loosen but do not remove nuts holding assembly to front engine mount studs. 15. Place a container under engine, remove oil filler plug/dip- stick, and oil drain plug and drain oil. Reinstall dipstick and drain plug. See 1.8 ENGINE OIL AND FILTER . 23. Remove fasteners under radiator assembly that hold cross member to frame. Gently pull bottom of radiator/oil cooler assembly forward. 16. Separate stator to regulator connector [46]. 24. Snap the plastic dust cap from the quick connect oil line fitting at the oil filter (oil out). 17. Remove top cooling fan connector [97T] from radiator cover by rocking first one way and with a finger pull the connector tab to compress butterfly peg. 25.

See Figure 5-18 . Close the OIL LINE REMOVER (Part No. HD-46503) over the oil line. Match the notches in the tool flange to the U-bends in the spring clip. 18. Separate top cooling fan wiring harness connector [97T] and bottom cooling fan connector [97B]. 26. See Figure 5-19 . Holding the oil line in the palm of the hand, rotate the tool to expand the spring clip out of the groove in the oil fitting. 19. Separate crank position sensor connector [79]. 20. attached. indicates locatio not remove coolan m n of the Both the oil line lines to radiator/oil cooler assem t drain ith shop towel or protective cover. 27.

With a cup under the fitting, use nd washers on each side of radiator the OIL LINE REMOVER (Part tor cover with chrome inlet bezels against the fitting to keep the s only enough pressure to hold pressure will prevent pulling the ting simultaneously. 28. Pull the oil line and the tool from e: Cooling System finger and thum OIL LINE REMOVER (Part No. HD-46503) pring clip expan the tool square line and tool fro the fitting.