2009 — Removal

HOME 5.8 RADIATOR AND OIL COOLER GENERAL The heat exchangers, or radiators, for both engine cooling and oil cooling are bolted together in a single radiator/oil cooler assembly. The radiator/oil cooler assembly is fasten to the frame with: sm00637 1 • Double threaded studs near the steering head. • Two pins and rubber grommets on the bottom of the oil cooler that fit the frame cross member. 2 REMOVAL 3 4 TOOL NAME PART NUMBER OIL LINE REMOVER HD-46503 LONG THIN SCREWDRIVER SNAP-ON SDD1410 1. Rear brake master cylinder reservoir 2. Chrome inlet bezel 3. Fastener and washer 4. Radiator cover Do not remove radiator filler cap when engine is hot.

The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) Figure 5-21. Right Side Radiator 7. See Figure 5-23 . Remove fastener and left radiator trim cover. 1. Allow cooling system to cool. NOTE death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 9. Push straight down to remove stator to regulator connector [46] from metal clip on side of radiator cover. 3. Remove negative battery cable. 4. Remove air box decorative cover, air box cover, air filter cover and air filter. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 10.

Push connectors and wire harnesses away from coolant drain plug up and behind shift lever. 11. Place a container under left side of radiator. 5. See Figure 5-23 . Remove fastener and right radiator trim cover. 6. Pull rear brake master cylinder reservoir straight away from its mounting slots in right side of radiator cover. 2009 VRSC Service: Cooling System 5-19 2. Remove right side cover and maxi-fuse. See 7.4 FUSE. MAXI- Before removing wiring h In particular, pay close that must be replaced. 8. Clip cable wrap tyin cause shaft position senso To prevent accidental vehicle start-up, which could