HOME sm00206 7. Lightly tug on oil line to verify that it is securely locked to fitting. 8. Check oil level and add oil if required. 9. Reinstall the negative battery cable. Tighten to 6.8-10.8 Nm (60-96 in-lbs ). 10. Install maxi-fuse and right side cover. 11. After running engine, a. Inspect oil fittings for oil leaks. b. Check oil level and add oil if required. c. Check coolant level in overflow bottle with coolant cold and motorcycle on jiffy stand. Continue to run engine, check level, and add antifreeze until fluid level remains at COLD FULL line with motorcycle on jiffy stand. See 1.7 COOLING SYSTEM . Figure 5-20. Flanged Oil Line 5-18 2009 VRSC Service: Cooling System Figure 5-19.
Oil Line Fitting with Spring Clip INSTALLATION 1. Install oil line fittings with o-ring into crankcase (oil in) and oil filter mount (oil out).Tighten to 40-44 Nm (29-32 ft-lbs). 2. See Figure 5-20. Supporting the radiator/oil cooler assembly, push the flanged oil line into the oil filter (oil out) fitting until it clicks in place under the spring clip. 3. Snap the plastic dust cap over the spring clip groove. 4. Install the radiator/oil cooler assembly. See 5.8 RADIATOR AND OIL COOLER. 5. Push the flanged oil line into the crankcase (oil in) fitting until it clicks in place under the spring clip.
NOTE Yellow witness band on the flanged oil line will not be visible if the oil line has been correctly snapped into the fitting. 6. Snap the plastic dust cap over the spring clip groove. NOTE Dust cap will not snap onto fitting if the oil line is not correctly installed on fitting. sm00635