HOME 5.7 OIL LINE FITTINGS GENERAL 7. With a cup under the fitting, use finger and thumb to hold the OIL LINE REMOVER (Part No. HD-46503) squarely against the fitting to keep the spring clip expanded. Use only enough pressure to hold the tool square. Excess pressure will prevent simultaneously pulling the line and tool from the fitting. Oil flows into engine at crankcase fitting. Oil flows out out of engine at oil filter fitting. REMOVAL TOOL NAME PART NUMBER OIL LINE REMOVER HD-46503 8. Pull the oil line and the tool from the fitting. 9. Repeat to remove the oil line from the remaining oil line fitting. 10. Remove oil line fittings and plug the holes until they can be replaced.
Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) 11. Remove radiator/oil cooler assembly. See 5.8 RADIATOR AND OIL COOLER . 12. Supporting the radiator/oil cooler assembly, pull the assembly far enough forward to access the oil filter (oil out) fitting. 1. Allow cooling system to cool. 2. Remove right side cover and maxi-fuse. 13. Snap the plastic dust cap from the quick connect oil line fitting at the oil filter. 14. Use the OIL LINE REMOVER (Part No. HD-46503) to remove the oil line from the fitting.
To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 15. Remove the radiator/oil cooler assembly. 3. Remove negative battery cable. sm00205 4. Snap the plastic dust cap from the quick connect oil line fitting at the crankcase (oil in) and slide it up the oil pipe. sm00633 Figure 5-18. Oil Line Remover Figure 5-17. Crankcase Oil Line (oil in) Fitting 5. See Figure 5-18 . Close the OIL LINE REMOVER (Part No. HD-46503) over the oil line. Match the notches in the tool flange to the U-bends in the spring clip. 6. See Figure 5-19 .
Rotate the tool to expand the spring clip out of the groove in the oil fitting. 2009 VRSC Service: Cooling System 5-17