2009 — Installation

HOME 11. Mate: a. Crank position sensor connector [79] halves. b. Top and bottom cooling fan connector [97T], [97B] halves. Connect the cables to the correct battery terminals. Failure to do so could result in damage to the motorcycle electrical system. (00215a) c. Stator to voltage regulator connector [46] halves. 12. Push top fan connector [97T] into radiator cover. 13. Cable wrap fan wiring harness to crank position sensor wiring harness and mounting both through frame clip. Do not over-tighten bolts on battery terminals. Use recommended torque values. Over-tightening battery ter- minal bolts could result in damage to battery terminals. (00216a) 14.

Install left and right side radiator covers. 15. Fill engine with oil. See 1.8 ENGINE OIL AND FILTER . 16. Install air filter bottom, velocity stacks, o-rings and breather hose. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 20. Install the negative battery cable. Tighten to 6.8-10.8 Nm (60-96 in-lbs ). 21. Install right side cover and maxi-fuse. 17. Loosen air bleed plug. Fill with GENUINE HARLEY-DAV- IDSON EXTENDED LIFE ANTIFREEZE & COOLANT through filler neck. See 5.3 ENGINE COOLANT . 22. After running engine, inspect oil fittings for oil leaks. Check oil level and add oil if required. 23.

After running engine, check coolant level in overflow bottle with coolant cold with motorcycle on jiffy stand. If level is below COLD FULL line, remove cap from overflow bottle and add antifreeze until fluid level reaches COLD FULL line. 18. Tighten air bleed plug to 9-11 Nm (80-97 in-lbs ) and install pressure cap. 19. Install air filter, air filter top and air filter cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 24. Continue to run engine, check level, and add antifreeze until fluid level remains at COLD FULL line with motorcycle on jiffy stand. Connect positive (+) battery cable first.

If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00068a) 2009 VRSC Service: Cooling System 5-23