2009 — Installation

HOME 5.9 OIL COOLER REMOVAL sm00643 Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) 1. Allow cooling system to cool. 2. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 3. Remove negative battery cable. 4. Remove oil lines from oil fittings. See 5.7 OIL LINE FIT- TINGS . 5. Remove the radiator/oil cooler assembly. See 5.8 RADI- ATOR AND OIL COOLER . 6.

See Figure 5-24 . With assembly on bench and holding a cup under each line, remove the fasteners holding oil line manifolds to oil cooler. Discard o-rings. NOTE If replacing oil lines, remove oil line bracket fastener and bracket with spacers bushings, grommets and washers. Figure 5-25. Oil Line Manifold 7. Remove fasteners holding oil cooler to engine coolant radiator. Remove oil cooler. INSTALLATION 1. See Figure 5-26 . Install oil cooler to engine coolant radi- ator. Tighten front and rear fasteners (3) to 10-12 Nm (89-106 in-lbs ). 2. If installing oil pipes: a. Route oil pipes in front and over top of engine coolant radiator. b.

Install radiator oil line bracket (1) over the oil lines and tighten fastener to 8-10 Nm (71-88 in-lbs ). c. Install new o-rings in the oil cooler ports. d. Install fasteners holding oil line manifolds to oil cooler. Tighten to 8-10 Nm (71-88 in-lbs ). e. See Figure 5-24 . Install spacer, bushings grommet, and washers to radiator/oil cooler assembly mounting bracket. 3. Install the radiator/oil cooler assembly. See 5.8 RADIATOR AND OIL COOLER . 5-24 2009 VRSC Service: Cooling System