HOME sm00726 sm00729 Figure 6-44. Output Shaft Seal Retainer Figure 6-42. Locating Pin Hole 7. See Figure 6-44 . Install two upper case fasteners in drive sprocket seal retainer. Do not tighten at this time. Figure 6-43. Output Shaft Attempting to assemble engine without the bearing locating pins in the correct position will cause engine damage. NOTE 8. See Figure 6-45 and Figure 6-33 . Carefully lower input shaft into case. Inspect to be certain that the alignment pins (6) on the bearing outer race are in the case holes and shifting forks are in the correct location. Attempting to assemble engine without the bearing locating pins in the correct position will cause engine damage. 6.
See Figure 6-43 and Figure 6-44 . Carefully lower output shaft into case. Inspect to be certain that the alignment pins on the bearing outer race are in the case holes. 9. See Install TRANSMISSION ASSEMBLY RETAINER TOOL (Part No. HD-45301) on input shaft. 10. Use SHIFT LEVER SUBSTITUTE (Part No. HD-45338) to dry shift transmission while rotating input and output shaft. Make sure transmission shifts through all gears NOTE Output shaft will turn freely when it is in the correct position. . 6-16 2009 VRSC Service: 5. See Figure 6-42. A SMALL dab of HARLEY-DAVIDSON HIGH-PERFORMANCE SEALANT around the output bearing locating pin hole will help to keep bearing from dropping during assembly.
This is ONLY DONE ON THE OUTPUT SHAFT FIRST GEAR BEARING. sm00729 Figure 6-45. Input Shaft NOTE sm00728 correctly. 11. Install neutral switch. See 7.24 e: Transmission NEUTRAL SWITCH