HOME sm00732 NOTE Crankshaft bearings must be replaced every time the cases are split for service. If the cam drive is not being serviced, crankshaft bearings can be replaced without removing the cam drive chain. 14. Replace the crankshaft bearings at this time. See 3.11 ENGINE BOTTOM END SERVICE . 15. See Figure 6-48 . Lubricate crankshaft bearing surfaces, input and output shaft and counterbalancer bearings with Harley-Davidson Motorcycle Oil 20W50. Use Lubriplate No. 105 Assembly Grease (NAPA Part No. 765-2651) on bearing shells. sm00738 Figure 6-46. Retain Input Shaft 12. See Figure 6-46. Install TRANSMISSION ASSEMBLY RETAINER (Part No. HD-45301) on input shaft as shown.
sm00734 Figure 6-47. Counterbalancer Alignment 13. See Figure 6-47. Install COUNTERBALANCER ALIGN- MENT PIN (Part No. HD-45311).With the alignment mark in the 2 o'clock position, the case hole and the index hole in the counterbalancer will align. Figure 6-48. Pre-Assembly Lubrication 2009 VRSC Service: Transmission 6-17 tall COUNTERBALANCER ALIGN- HD-45311).With the alignment mark on, the case hole and the index hole er will align. Figure 6-48. Pre-Assemb 2009 VRSC Serv ly Lubrication ice: Transmission 6-17 MENT PIN (Part No. HD-45311)