HOME sm00740 18. See Figure 6-50 . Install LOWER CRANKCASE ALIGN- MENT DOWELS (Part No. HD-45310). NOTE If dipstick has not been removed, do so at this time. 19. See Figure 6-41 . Check that upper crankcase input bearing retainer is loosely in position. sm00887 Figure 6-49. Retain Crankshaft Thrust Bearing 16. See Figure 6-49 . If engine was not at TDC, position the CRANKSHAFT ASSEMBLY RETAINER (Part No. HD- 45316) to hold crankshaft thrust bearing half in place while attaining TDC. Rotate engine toward front cylinder only. Do not rotate engine toward rear cylinder, as engine damage can result. (00409c) Figure 6-51. Apply Sealant 17. Position crankshaft assembly at TDC. 20.
See Figure 6-51 and Figure 6-52 . Cut HARLEY-DAV- IDSON HIGH-PERFORMANCE SEALANT (Part No. 99650-02) applicator tip at first step. sm00743 NOTES • Carefully clean case mating surfaces (gray shaded area). • Apply 1 mm (0.04 in.) VRSC Crankcase Sealant (HD- 99650-02) following black line. • Apply sealant only as indicated - DO NOT seal all mating surfaces. NOTE Excess VRSC Crankcase Sealant squeezed into the crank- cases during assembly can clog the oil pick up. 21. Adjust speed and pressure to apply a 1 mm (0.04 in.) bead of sealant to the lower case half. Figure 6-50. Lower Crankcase Alignment Dowels (HD-45310) 6-18 2009 VRSC Service: Transmission 1 mm (0.04 in.