HOME • Lower case with the transmission gears in place is heavy. Get assistance when lifting lower case. NOTES sm00747 • It is also possible when using rolling engine stand and engine cradle to mate cases vertically when engine is positioned with starter facing upward. 22. See Figure 6-54 . Position lower case half over the LOWER CRANKCASE ALIGNMENT DOWELS (Part No. HD- 45310). 23. See Figure 6-55 .When the counterbalancer gear and the primary crankshaft gear are close to engagement, remove the COUNTERBALANCER ALIGNMENT PIN (Part No. HD-45311). NOTE Confirm the correct alignment of the counterbalancer gear and the primary crankshaft gear timing marks.
Engine damage will occur if the counterbalancer gear and the primary crankshaft Figure 6-55. Lower Case Over Alignment Dowels 24. See Figure 6-56. Hand position the counterbalancer gear sm00748 so the timing marks are aligned exactly as shown. 25. Verify that transmission input and output shafts spin freely. 26. See Figure 6-53. Match and thread-in all 19 case fasteners. NOTE Be sure to tighten counterbalancer gear at this time. 27. See Figure 6-57. Tighten counterbalancer gear. Hold crankshaft with 1/2 in. drive extension and wrench while tightening counterbalancer gear fastener to 50 Nm (37 ft- lbs) plus 90 degrees. sm00744 Figure 6-56. Marks Aligned sm00749 Figure 6-54.
Lower Case Over Alignment Dowels Figure 6-57.Tighten Counterbalancer Gear NOTE The correct torque sequence for the case fasteners requires 2 steps. First, all 19 case fasteners including the 4 main bearing 6-20 2009 VRSC Service: Transmission Figure 6-57.Tighten Count NOTE The correct torque sequence for th 2 steps. First, all 19 case fasteners in e: Transmission erbalancer Gear e case fasteners requires cluding the 4 main bearing