2009 — Assembly

HOME bolts are tightened to 25 Nm (18.4 ft-lbs). Second, the 4 main bearing bolts are backed off one full turn, tightened to 15 Nm and then turned an additional 90 degrees. Use the detailed procedure presented in the following steps. Refer to Table 6-5 . NOTE The notation for this torque sequence is written: 25 Nm - 360 degrees,15 Nm + 90 degrees. 31. Dab a second mark next to each torqued main bearing bolt to identify which bolts have been tightened with the complete sequence. 28. See Figure 6-59 .Tighten in sequence all 19 case fasteners 29. Dab a marker next to each torqued fastener as it is tightened. to 25 Nm (18.4 ft-lbs). sm00751 30. See Figure 6-59 .

Torque in sequence the 4 M10 x 150 main bearing bolts (1, 2, 3, 4) in this sequence: a. Loosen (counterclockwise) each main bearing bolt (1, 2, 3, 4) one full turn (- 360 degrees). b. See Figure 6-59 . Torque in sequence each main bearing bolt (1, 2, 3, 4) to 15 Nm (11 ft-lbs). c. See Figure 6-58 . Position the TORQUE ANGLE GAUGE (Part No. Snap-on TA360) per instruction sheet and tighten each bolt an additional quarter turn (+ 90 degrees). Figure 6-58.Torque Angle Gauge sm00895 12 10 6 3 4 15 18* 8 14 7 13 16 19* 17 9 1 1 5 2 1 1. M10x150 (Part No. 968M) 11. M8x40 (Part No. 970M) 2. M10x150 (Part No. 968M) 12. M8x90 (Part No. 1025M) 3. M10x150 (Part No. 968M) 13. M8x40 (Part No. 970M) 4.

M10x150 (Part No. 968M) 14. M8x40 (Part No. 970M) 5. M8x120 (Part No. 973M) 15. M8x90 (Part No. 1025M) 6. M8x160 (Part No. 972M) 16. M8x40 (Part No. 970M) 7. M8x90 (Part No. 1025M) 17. M8x40 (Part No. 970M) 8. M8x90 (Part No. 1025M) 18. M8x40 (Part No. 970M) (*insert from upper case 9. M8x120 (Part No. 973M) half) 10. M8x120 (Part No. 973M) 19. M8x40 (Part No. 970M) (*insert from upper case half) Figure 6-59. Engine Case Torque Sequence 2009 VRSC Serv ice: Transmission 6-21