2009 — Removal

HOME 6.4 COUNTERBALANCER BEARING REPLACEMENT REMOVAL TOOL NAME PART NUMBER sm00749 HD-34902-B BIG-TWIN MAINSHAFT PRIMARY BEARING RACE REMOVER AND INSTALLER BALANCER BEARING REMOVER/INSTALLER TOOLS HD-45490 HD-46582 COUNTERBALANCER BEARING INNER RACE REMOVER AND INSTALLER PLIERS SNAP-ON SRPC3890 In order to break counterbalancer gear loose, it is necessary to hold the counterbalancer gear with the crankshaft drive gear. Once the fastener is loose, the engine case halves can be NOTE Figure 6-64.Tighten Counterbalancer Gear 3. See Figure 6-65 . Remove fastener and gently pry counter- balancer gear from shaft. Discard gear and fastener. Figure 6-65.

Remove Counterbalancer Gear NOTE The counterbalancer gear retaining fastener is one-time-use only. Always use a new fastener when installing counterbal- ancer gear. sm00772 NOTE Use PLIERS (Part No. Snap-on SRPC3890) for removal/installation of the retaining rings. 4. See Figure 6-66 . Remove outer retaining ring. 5. See Figure 6-67 balancer shaft. 6-24 2009 VRSC Service: Transmission separated. See 6.3 TRANSMISSION. 1. See Figure 6-64. Before separating the case halves and removing the crankshaft, use a 1/2 in. drive extension and breaker bar to rotate engine clockwise until timing marks are aligned. Do not use Counterbalancer Alignment Pin to remove or tighten counterbalancer fastener.

Pin can bend and bind in hole. (00550b) 2. Hold crankshaft with a 1/2 in. drive extension and wrench and loosen counterbalancer gear retaining fastener. sm00771 etaining Ring f BALANCER BEARING BALANCER BEARING (Part No. HD-45490)