2009 — Removal

HOME 6. See Figure 6-68 . The counterweight must be rotated and held upright in the position shown to prevent binding against the case. The tool will pull the outboard bearing and balancer through the case. When the bearing is free, remove tool and bearing. sm00775 7. See Figure 6-69 . Counterbalancer can be removed from engine. Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 8. See Figure 6-70 . Remove outboard inner retaining ring. Figure 6-69. Remove Counterbalancer sm00773 sm00776 Figure 6-67. Counterbalancer Tool Figure 6-70.

Outboard Inner Retaining Ring sm00774 9. See Figure 6-72 . Position the bearing removal insert as shown. Note the position of the flat. 10. See Figure 6-73 . Thread puller rod into insert. 11. See Figure 6-74 . Hold screw end of puller and turn large nut to remove the bearing. 12. See Figure 6-71 . Remove inboard retaining ring. nterbalancer Outboard Bearing Figure 6-71. Counterbalancer In 2009 VRSC Serv board Retaining Ring ice: Transmission 6-25