2009 — Installation

HOME sm00785 sm00787 Figure 6-81. Inner Balancer Bearing Installation 4. See Figure 6-81 . Using the bearing installer from the BALANCER BEARING REMOVER/INSTALLER TOOLS (Part No. HD-45490), drive the inner counterbal- ancer bearing into the case with a soft faced hammer until the retaining ring groove is visible. Figure 6-79. Outboard Bearing Race 5. See Figure 6-82 . Install inner retaining ring. Be certain . Install outboard bearing inner retaining NOTE . Position counterbalancer in case. NOTE of the bearing with the manufacturer's lettering/part number. Figure 6-80. Installed Inner Races 8. See Figure 6-85 . Start bearing by hand.

Insert tapered guide from the BALANCER BEARING REMOVER/INSTALLER TOOLS (Part No. HD-45490). 3. See Figure 6-80 . Inboard bearing race is even with the end of the counterbalancer shaft. Outboard bearing race • installation. • number. 6-28 2009 VRSC Service: sm00786 1 2 1. Outboard 2. Inboard retaining ring is fully 6. See Figure 6-83. In ring. Be certain reta Use Harley-Davidson M lubricate bearing surfac installation process. Use (NAPA Part No. 765-265 7. See Figure 6-84. Po When installing bearings of the bearing with the m t shoulder of counterbalancer.

NOTES Motorcycle Oil 20W50 to thoroughly aces and case bores before bearing ings, always drive/push against the ith the manufacturer's lettering/part Figure 6-82. Inner Balancer B e: Transmission earing Installation