HOME sm00789 10. See Figure 6-87 . Install new outboard retaining ring. Be certain retaining ring is fully seated in the case groove. NOTE The counterbalancer gear can be installed on the balancer shaft with the counterbalancer gear fastener loosely holding the counterbalancer in place. The counterbalancer is either timed to the crankshaft during the assembly of the case halves, or after the case halves have been assembled. 11. See Figure 6-88 . Position balancer shaft master tooth at 11 o'clock. 12. Insert COUNTERBALANCER ALIGNMENT PIN (Part No. HD-45311). 9. Transmission 6-29 Figure 6-83. Outboard Bearing Inner Retaining Ring sm00790 Figure 6-84.
Position Counterbalancer sm00791 sm00792 Figure 6-86. Outboard Bearing Installation sm00793 Figure 6-87. Outboard Retaining Ring Installation Figure 6-85. See Figure 6-86. U Insert Tapered Guide se the driver from the BALANCER R/INSTALLER TOOLS (Part No. HD- ring in with a soft faced hammer until ove is exposed. 2009 VRSC Serv BEARING REMOVE 45490)