2009 — Installation

HOME sm00794 sm00795 Figure 6-89. Counterbalancer Gear Master Tooth Flat tighten counterbalancer fastener. Pin can bend and bind in hole. (00550b) 16. Remove COUNTERBALANCER ALIGNMENT PIN (Part No. HD-45311). sm00749 17. Install a new counterbalancer gear fastener. 18. See Figure 6-91 . Hold crankshaft with 1/2 in. drive exten- sion and wrench while tightening counterbalancer gear fastener to 50 Nm (37 ft-lbs) plus 90 degrees. Figure 6-91.Tighten Counterbalancer Gear 6-30 2009 VRSC Service: Transmission Figure 6-88. Counterbalancer Shaft Master Tooth 13. See Figure 6-90. Position counterbalancer gear with timing marks aligned to crankshaft drive gear. 14. See Figure 6-89.

Align the master tooth flat with the cor- responding master tooth on the balancer shaft. 15. Gently rock crankshaft until counterbalancer shaft master tooth engages counterbalancer gear master tooth flat and gear slides onto shaft. Gear should seat with hand pres- sure. sm00796 lat and d pres- Do not use Counterbalancer Alignment Pin to rem Figure 6-90.Timing Marks ove or