HOME 6.5 SHIFT SHAFT AND SEAL GENERAL This procedure is shown with the engine removed. The shift shaft and seal may be replaced without removing the engine from the chassis. sm00798 REMOVAL Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 1. See Figure 6-92 . Remove the outer retaining ring (zinc plated). 2. See Figure 6-93 . Drill small hole in the shift shaft seal. Thread sheet metal screw into the hole. 3. See Figure 6-94 . Gently pry seal from engine case. Figure 6-93. Shift Shaft Seal Figure 6-94.
Remove Shift Shaft Seal Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 4. See Figure 6-95 . With the shaft seal removed, the inner retaining ring (black) is exposed. Remove the retaining ring. 5. Remove shift shaft using hand effort. 6. See Figure 6-96 . The shift actuator is spring loaded and will move away from alignment with the case hole when the shift shaft is removed. 2009 VRSC Service: Transmission 6-31 sm00797 Figure 6-92. Shift Shaft Outer Retaining Ring sm00799