HOME 6.6 OUTPUT SHAFT GENERAL This procedure starts with the input shaft and output shaft removed from the engine. See 3.10 UPPER AND LOWER CRANKCASE SEPARATION for removal of input shaft and output shaft. sm00805 DISASSEMBLY - 2ND GEAR END TOOL NAME PART NUMBER FINAL DRIVE SPROCKET FLANGE LOCKING TOOL HD-45331-A FINAL DRIVE SPROCKET LOCKING DEVICE INSTALLER HD-45332 METRIC BOLT GRIP PULLER SET SNAP-ON CJ2001 Bearing Removal - 2nd Gear End Figure 6-100. Modify Socket for Output Nut Removal 1. See Figure 6-99 . Remove lock ring from output flange nut. 2. See Figure 6-100 . Place output shaft in FINAL DRIVE SPROCKET FLANGE LOCKING TOOL (Part No.
HD- 45331-A) to remove the output shaft nut, use a 30 mm socket cut down to 39.6 mm (1.56 in.) to clear the flange. sm00806 NOTE Output flange nut is one time use only, but do not discard at this time. Retain removed nut to pull flange on shaft during assembly. 3. See Figure 6-101 . Obtain three 3/8 x5 inch bolts with washers and nuts and install a METRIC BOLT GRIP PULLER SET (Part No. Snap-on CJ2001) onto the flange and shaft. Remove output shaft drive flange and seal retainer. 4. See Figure 6-102 . Remove output shaft bearing. Figure 6-101. Removing Output Drive Flange If no further disassembly of this end is needed, go to step 5. If further disassembly is needed, go to step 13.
NOTE sm00807 . Lubricate new Transmission 6-33 sm00804 Figure 6-102. Output Shaft Be Bearing Installation - 2nd Gear 1. See Figure 6-104 and Figure 6-103 bearing. Position bearing on shaft with b pin offset toward gears and press o Figure 6-99. Output Shaft Lock Ring pressing ring so installation force is on th 2009 VRSC Service: Tra Bearing Installation - 2nd 1. See Figure 6-104 and Figur bearing. Position bearing on sh pin offset toward gears and Output Shaft Lock Ring pressing ring so installation forc 2009 VRSC Serv aft with b press o e is on th ice: Tra Figure 6-99.