2009 — Disassembly - 2nd Gear End

HOME sm00884 7 5 1 4 3 2 6 6 8 5 1 4 3 2 6 6 1. 1st gear 2. 2nd gear 3. 3rd gear 4. 4th gear 5. 5th gear 6. Bearing alignment pins (Install with offset toward gears) 7. Input shaft 8. Output shaft Figure 6-104.Transmission Input Shaft and Output Shaft Assemblies 2. See Figure 6-105 . Replace flange seal and o-ring. Lub- ricate the flange seal with Harley-Davidson Motorcycle Oil 20W50. 3. See Figure 6-106 . Slide seal retainer on the output flange. 4. Place output shaft in FINAL DRIVE SPROCKET FLANGE LOCKING TOOL (Part No. HD-45331-A) to install the output shaft nut. NOTE Do not attempt to drive flange on with a hammer. Damage to the output shaft can result. 5.

Use the old output shaft nut to pull the output flange on the shaft. 6. See Figure 6-107 . Remove and discard the old output shaft nut. 2009 VRSC Service: Transmission 6-35