HOME sm00809 sm00811 1 2 Figure 6-107. Remove/Tighten Output Shaft Nut 7. See Figure 6-108 . Install a new o-ring (2) behind a new drive sprocket flange nut (3) and install the new flange nut (3). Tighten nut to 160 Nm (118 ft-lbs). 1. Drive flange seal 2. O-ring Figure 6-105. Seal Retainer 8. Position lock ring (4) over flange nut (3). 9. See Figure 6-109 . With three 3/8 x5 inch bolts with washers and nuts and install a METRIC BOLT GRIP PULLER SET (Part No. Snap-on CJ2001) onto the flange and shaft. Turn screw down against the FINAL DRIVE SPROCKET LOCKING DEVICE INSTALLER (Part No. HD-45332) to crimp lock ring in position. sm00810 10. Cap nut.
NOTE Never use a hammer to hit on the FINAL DRIVE SPROCKET LOCKING DEVICE INSTALLER (Part No. HD-45332). Damage to output shaft bearing could result. sm00899 2 1 5 Figure 6-106. Seal Retainer and Output Flange 4 3 1. Output shaft flange 2. O-ring 6-36 2009 VRSC Service: 3. Flange nut 4. Lock ring 5. Plastic cap Figure 6-108. Output S e: Transmission haft Components