HOME Figure 6-119.Thrust Washer 8. See Figure 6-120 . Install new bearing with bearing align- ment pin offset toward the gears. Use a pressing ring so installation force is on the inner race only. 7. See Figure 6-119 . Check position of stepped thrust washer. Step should face 1st gear, flat side toward bearing. Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 9. Install retaining ring. 10. See Figure 6-104 . Remove stepped washer and 1st gear (1). 2009 VRSC Service: Transmission 6-39 sm00821 Figure 6-118. 1st Gear Bearing Removal 6.
See Figure 6-118. Remove and discard 1st gear bearing. NOTE Once removed, transmission bearings MUST be replaced. NOTE If no further disassembly of this end is needed, go to step 7. If further disassembly of this end is needed, go to step 8. Bearing Installation - 1st Gear End sm00822 sm00823 Figure 6-120. 1st Gear Bearing Installation