HOME 6.7 INPUT SHAFT DISASSEMBLY - 2ND GEAR END TOOL NAME PART NUMBER sm00836 HD-34902-B BIG-TWIN MAINSHAFT PRIMARY BEARING RACE REMOVER AND INSTALLER Bearing Removal - 2nd Gear End Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 1. See Figure 6-133 . Remove retaining ring at 2nd gear crankcase bearing. ment pin offset toward the gears. Use a pressing ring so installation force is on the inner race only. Figure 6-133. 2nd Gear Bearing Retaining Ring Wear safety glasses or goggles when removing or installing retaining rings.
Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 2009 VRSC Service: Transmission 6-43 sm00835 Figure 6-134. 2nd Gear Bearing Removal 2. See Figure 6-134. Use puller to remove 2nd gear bearing. To protect the end of the shaft use BIG-TWIN MAINSHAFT PRIMARY BEARING RACE REMOVER AND INSTALLER (Part No. HD-34902-B). NOTE If no further disassembly of this end is needed go to step 3. If further disassembly of this end is needed go to step 4. Bearing Installation - 2nd Gear End 1. See Figure 6-135. Install new bearing with bearing align- BIG-TWIN MAINSHAFT MARY BEAR ING RACE REMOVER AND