2009 — Installation

HOME 7.2 ELECTRONIC CONTROL MODULE (ECM) GENERAL 2. Install electrical caddy to rear fender, locking all tabs into place. The electronic control module (ECM) is mounted under the passenger pillion. Refer to the VRSC ELECTRICAL DIA- GNOSTIC MANUAL for information on the function and testing of the electronic control module. 3. Insert ECM connector (1) [78B] into ECM latch locks. 4. Install maxi-fuse. 5. Install right side covers. The electronic control module cannot be repaired. Replace the unit if it fails. NOTE 6. Install passenger pillion and close seat.

REMOVAL sm01659 2 3 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 4 1. Disable alarm system (if equipped). 1 2. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 3. Open seat and remove passenger pillion. 4. See Figure 7-1 . Lift upward on electrical caddy and depress latch (2) on ECM connector (1) [78B] and discon- nect from ECM. 1. ECM connector [78B] 2. Latch 3. Electrical caddy 4. ECM (Electronic Control Module) 5. Push downward on ECM and remove ECM (1) from bottom of electrical caddy. INSTALLATION Figure 7-1. ECM 1. See Figure 7-1 .

Install ECM (4) into bottom of electrical caddy (3) and press firmly until ECM is fully seated. 2009 VRSC Service: Electrical 7-3